Aeon Laser Mira 7 450mm x 700mm Bed 90W CO2 Laser Engraving Cutting Machine

  

Aeon Laser Mira 7 450mm x 700mm Bed 90W CO2 Laser Engraving Cutting Machine. The Aeon Mira 7 is a professional desktop laser engraving/cutting machine. The working area is 700mm x 450mm with a removable honeycomb table and blade table for material cutting. The machine has a water cooler, exhaust fan and air pump built inside providing a very compact, clean and modern design. 90W RECI W2 CO2 Laser Tube.

Working area of 450mm x 700mm. Machine Size: 1100mm x 845mm x 480mm.

High speed digital stepper motors. Mechanical Z-Axis Up/Down Table 15cm. Fan cooled (3000) water chiller. 105W Built-in air assist pump.

Removable Honeycomb table with Blade table below. Front access for oversized items. Camera to view working area from connected computer. Ethernet, USB, WiFi connection options.

Windows / Mac compatible with LightBurn Software. Machine Stand Included (approximate weight 50KG). Machine has some cosmetic scuffs on left side paintwork due to previous transit between locations. Red dot laser pointer is not working (diagnosed by Aeon as requiring a replacement 5v power supply). This could likely be done easily by an experienced laser technician but was not needed for our use. The machine auto-focus has been disconnected (parts included). We found it easier to use manual focus with more reliable results. The air assist control button does not toggle on/off. Air assist is working and activates when the machine is powered on. There is no native Ethernet port on this machine however wired Ethernet connection can be achieved if needed by disconnecting the WiFi module and extending the Ethernet Cable to a computer/network switch.

Important terms of sale notes. Collection only due to the size and heavy weight.

Previous location move required two strong men to lift the machine onto a sack trolley then out to a van for road transit. Safety glasses are not included (10600nm CO2 Laser safety goggles should be worn at all times when operating this machine).

This Aeon Mira 7 is a fairly advanced device probably not suitable for beginners so it would be assumed the person or business purchasing has prior experience working with CO2 lasers for material engraving/cutting. The mirrors will require professional re-alignment after machine transit before use to ensure the laser path is correct across all four corners of the working area. Any further questions or details not covered please send a message and will be glad to answer any queries.